HP StorageWorks P9000 Manual page 247

Table 59 Error codes (part code 7005) (continued)
Part Error Error Message
Code Number
7005 68738 The command has been rejected,
because the specified S-VOL is a Thin
Provisioning volume not associated with
a pool.
7005 68739 The command has been rejected,
because the specified reserved volume
is a Thin Provisioning volume not
associated with a pool.
7005 68743 The command has been rejected,
because Quick Format is performed on
the specified P-VOL.
7005 68744 The command has been rejected,
because Quick Format is performed on
the specified S-VOL.
7005 68750 The Quick Restore command has been
rejected, because the specified pair is
composed of the Thin Provisioning
volume and the volumes other than Thin
Provisioning volume.
7005 68755 The Quick Restore command has been
rejected, because device information
(Inquiry information) of P-VOL and S-VOL
was different in the specified pair.
7005 68760 Quick Restore cannot be executed,
because the configuration is being
backed up in the target volume. Please
wait for a while, then retry the operation.
7005 68808 The command has been rejected,
because the specified P-VOL is a Thin
Provisioning volume whose capacity is
being added.
7005 68809 The command has been rejected,
because the specified S-VOL is a Thin
Provisioning volume whose capacity is
being added.
7005 68810 The command has been rejected,
because the specified reserved volume
is a Thin Provisioning volume whose
capacity is being added.
7005 68814 The Initialize function cannot be
executed, because a Continuous Access
Synchronous pair or a Continuous
Access Journal pair is created by using
Thin Provisioning volumes.
7005 68835 The command has been rejected,
because the specified P-VOL is used by
a pair of Snapshot, which is registered
in the CTG.
7005 68836 The command has been rejected,
because the specified S-VOL is used by
a pair of Snapshot, which is registered
in the CTG.
Recommended Action
Associate the Thin Provisioning volume
with a pool, then retry the operation.
Associate the Thin Provisioning volume
with a pool, then retry the operation.
Retry the operation after the Quick
Format has completed.
Retry the operation after the Quick
Format has completed.
Quick Restore cannot be executed by
the current pair configuration.
Quick Restore cannot be executed in the
current pair configuration. Select a pair
where the device information (Inquiry
information) is the same, and execute
Quick Restore.
Wait for a while, then retry the
operation.
The operation is not available because
the target volume has capacity changes.
Check the capacity of the volume and
retry the setting.
The operation is not available because
the target volume has capacity changes.
Check the capacity of the volume and
retry the setting.
Confirm the capacity of the volume and
retry the setting.
Delete the Continuous Access
Synchronous pair or Continuous Access
Journal pair that is using Thin
Provisioning volumes, then retry the
operation.
Release the pair of Snapshot that is using
the specified P-VOL, then retry the
operation.
Release the pair of Snapshot that is using
the specified S-VOL, then retry the
operation.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
Part code 7005 247