HP StorageWorks P9000 Manual page 240

Table 59 Error codes (part code 7005) (continued)
Part Error
Code Number
7005 8619
7005 8622
7005 8623
7005 8624
7005 8625
7005 8626
7005 8627
7005 8628
7005 8629
7005 8630
7005 8631
7005 8632
7005 8633
7005 8634
7005 8635
7005 8636
7005 8637
7005 8638
7005 8639
240 Message (part code group 7nnn)
Error Message
The specified S-VOL is defined as a
source volume for Auto LUN.
The command has been rejected,
because the specified volume is used as
P-VOL of Continuous Access Synchronous
pair.
The command has been rejected,
because the specified volume is used as
S-VOL of Continuous Access Synchronous
pair.
The command has been rejected,
because there is no pair to be operated.
The P-VOL(S-VOL) and S-VOL(T-VOL)
have the same number.
The SMPL command was rejected,
because the high-speed Split was in
progress.
The Pairresync operation has been
rejected, because pair status is
COPY(SP).
The operation of the L1 pair failed
because the L2 pair was in COPY(SP)
status or PSUS(SP) status.
The status mode specification is invalid.
The status mode type is invalid.
The specified CU number is invalid.
The timing of issuing the command is
invalid.
The abnormal status is invalid.
The volume specified as a reserved
volume is already defined as a reserved
volume for Auto LUN.
The specified P-VOL is defined as a
reserved volume for Auto LUN.
The specified S-VOL is defined as a
reserved volume for Auto LUN.
The specified P-VOL is used as a source
volume for Auto LUN.
The command has been rejected,
because the specified P-VOL is set for
use in Cache Residency.
The command has been rejected,
because the specified S-VOL is set for
use in Cache Residency.
Recommended Action
Release the Auto LUN setting.
The P-VOL of Continuous Access
Synchronous pair cannot be used as a
reserved volume.
Specify another volume.
The S-VOL of Continuous Access
Synchronous pair cannot be used as a
reserved volume.
Specify another volume.
Confirm whether the volumes specified
for P-VOL and S-VOL are correct or not.
Check the specified volume number.
After the high-speed Split is completed,
retry the operation.
Wait until the status of the pair changes
to PSUS.
Wait until the L2 pair status changes to
PSUS, then retry the operation.
Check the contents, and retry.
Check the contents, and retry.
Please contact HP Technical Support.
Please contact HP Technical Support.
Please contact HP Technical Support.
Specify other volume(s), or release the
Auto LUN Setting.
Specify other volume(s), or release the
Auto LUN Setting.
Specify other volume(s), or release the
Auto LUN Setting.
Specify other volume(s), or release the
Auto LUN setting.
You cannot execute the specified
operation. Release the Cache Residency
setting for the operation.
You cannot execute the specified
operation. Release the Cache Residency
setting for the operation.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
E
E
W
W
W
W
W
W