HP StorageWorks P9000 Manual page 214

Table 53 Error codes (part code 6505) (continued)
Part Error
Code Number
6505 68863
6505 68870
6505 68885
6505 68886
6505 68887
6505 68888
6505 75021
6505 78003
6505 78004
6505 78050
6505 78051
6505 78066
214 Message (part code group 6nnn)
Error Message
The operation failed, because the
number of assignable remote command
device to a mirror exceeded the
maximum.
The operation failed, because a remote
command device was not assigned to
the specified mirror.
The operation failed, because the
specified volume was a quorum disk.
The operation failed, because the remote
storage system did not support the
specified operation.
The operation failed, because the
specified primary data volume was as
follows:
This volume was used as T-VOL of
Compatible FlashCopy.
This volume was used as M-VOL of
Continuous Access Synchronous Z,
and it was suspended by either of the
following settings:
It was a pair of synchronous
consistency group.
It was a pair that the "Cylinder" was
set to "Difference Management."
The operation failed, because the
specified "primary data volume" was
used as T-VOL of Compatible FlashCopy
that might be in the abnormal state due
to a failure.
The specified operation cannot be done
because there is an LDEV that has been
set to a different resource group.
The specified journal cannot be used.
The specified consistency group cannot
be used.
The operation failed because the
specified capacity of the primary data
volume is not supported by the current
microcode version.
The operation failed because the
specified capacity of the secondary data
volume is not supported by the current
microcode version.
The operation failed. The Mainframe
Fibre CHA of RCU is not mounted or all
the Mainframe Fibre CHA are blocked.
Recommended Action
Check the number of remote command
devices which has been assigned to a
mirror.
Check if a remote command device was
assigned to the specified mirror.
Release the quorum disk, or select
another volume.
Confirm whether the remote storage
system supports the specified operation.
Confirm the relationship status of
Compatible FlashCopy and the pair
status of Continuous Access Synchronous
Z.
Confirm the relationship status of the
Compatible FlashCopy.
Specify LDEVs defined in the same
resource group.
Check the specified journal.
Check the specified consistency group.
Check the specified capacity of the
primary data volume and the current
microcode version.
Check the specified capacity of the
secondary data volume and the current
microcode version.
Please contact HP Technical Support.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
E