HP StorageWorks P9000 Manual page 160

Table 50 Error codes (part code 6005) (continued)
Part Error
Code Number
6005 56524
6005 57005
6005 58319
6005 58320
6005 58321
6005 58322
6005 58357
6005 58358
6005 58359
160 Message (part code group 6nnn)
Error Message
This function cannot be used by the
storage partition administrator.
An error occurred during SVP
processing.
A pair cannot be created because the
specified M-VOL is used by Continuous
Access Journal or Continuous Access
Journal Z.
The operation failed because the
specified R-VOL was used by
Continuous Access Journal or
Continuous Access Journal Z.
The pair cannot be created because the
specified M-VOL is a LUSE volume that
is set across multiple CLPRs.
The pair cannot be created because the
specified R-VOL is a LUSE volume that
is set across the multiple CLPRs.
A pair cannot be created, because you
tried to create a volume pair formed
with a volume to which VMA is set by
Data Retention and a volume without
VMA.
A pair cannot be created, because the
set processing of VMA that is used for
Data Retention has not been completed
for the specified P-VOL.
A pair cannot be created, because the
set processing of VMA that is used for
Data Retention has not been completed
for the specified S-VOL.
Recommended Action
Please contact HP Technical
Support.
If the problem persists
despite retrying, please
contact HP Technical
Support.
Select another volume, and
retry the operation.
If the Add Pair (Paircreate)
operation failed:
When the RCU runs on
the 2DC configuration in
which the Continuous
Access Journal
cooperates, wait for a
while until the pair status
of the Continuous Access
Journal becomes "PAIR,"
then retry the operation.
When the RCU runs on
the configuration other
than the 2DC
configuration in which
the Continuous Access
Journal cooperates,
specify another volume
for R-VOL, then retry the
operation.
If the Pairresync operation
failed, resume the
Continuous Access Journal
pair volume first.
Select another volume and
retry the operation.
Select another volume, and
retry the operation.
Check to ensure that you did
not mistakenly attempt to
create a volume with or
without VMA.
Wait a while, then retry the
operation.
Wait a while, then retry the
operation.
Severity Level
E
E
W
W
W
W
W
W
W