HP StorageWorks P9000 Manual page 153

Table 50 Error codes (part code 6005) (continued)
Part Error Error Message
Code Number
6005 8849 Specified volume is not part of Remote
Copy pair (Not in Duplex(PAIR),
Pending(COPY), Suspend(PSUS) state).
6005 8850 Invalid RCU serial number, SSID, Link
Address or Controller ID.
6005 8851 The specified volume is not a R-VOL.
6005 8852 R-VOL status change failed after M-VOL
status change. Confirm R-VOL status.
6005 8854 Delete Pair(Pairsplit-S) operation failed
because M-VOL is in Simplex(SMPL)
status.
6005 8855 Delete(Pairsplit-S) operation failed
because specified volume or other
volume in the same group is in status
transition.
6005 8860 An internal error occurred.
6005 8861 An internal error occurred.
Recommended Action
The specified volume is not
part of a Continuous Access
Synchronous pair. Check the
volume.
Check the serial number,
SSID, link address and
controller ID of the RCU, and
set the correct value. Then
retry the operation. If the
same error occurs, please
contact HP Technical
Support.
Refresh the window, and
check whether the specified
volume is a R-VOL.
Confirm the R-VOL status.
The operation failed,
because of one of the
following reasons:
The specified volume is
simplex.
There is no duplex,
duplex-pending, or
suspend volume in the
group.
Verify the volume status, and
retry the operation.
The operation failed,
because of one of the
following reasons:
The status of the specified
volume or another
volume in the same group
is Deleting.
The status of the specified
volume or another
volume in the same group
is Suspending.
Wait for the transition of
status to complete, then retry
the operation.
If the transition of status does
not occur, delete the volume
by using the "Force" mode
or the "Delete pair by force"
option.
Please contact HP Technical
Support.
Please contact HP Technical
Support.
Severity Level
W
W
W
W
W
W
E
E
Part code 6005 153