HP StorageWorks P9000 Manual page 143

Table 50 Error codes (part code 6005) (continued)
Part Error Error Message
Code Number
6005 8735 Invalid RCU serial number, SSID, Link
Address or Controller ID.
6005 8736 The specified RCU or SSID contains
some Remote Copy volume pairs.
6005 8737 An internal error occurred.
6005 8738 Remote Copy is not supported under
the MCU Controller emulation type.
6005 8739 NVS status of MCU is not active.
6005 8740 NVS status of RCU is not active.
6005 8741 The logical paths between the MCU
and RCU are not established.
6005 8742 Pinned track(s) exists on the M-VOL.
6005 8743 Pinned track(s) exists on the R-VOL.
Recommended Action
Check the serial number,
SSID and link address of the
RCU, and set the correct
value. Then retry the
operation. If the same error
occurs, please contact HP
Technical Support.
Delete all Remote Copy
volume pairs of the specified
RCU or SSID, and retry the
operation.
Please contact HP Technical
Support.
The emulation type of the
MCU does not support
Continuous Access
Synchronous. If you want to
use Continuous Access
Synchronous, please contact
HP Technical Support.
The MCU NVS status
specified by the host is not
active. Set the NVS to "on"
for the MCU, using any
attached host, then retry the
operation.
The RCU NVS status
specified by the host is not
active. Use any attached
host to set the NVS to "on"
for the MCU, then retry the
operation.
Check the path status
between the MCU and the
RCU.
Check the status of the
M-VOL tracks, and clear the
pinned tracks.
Check the status of the
R-VOL tracks, and clear the
pinned tracks.
Severity Level
W
W
E
W
W
W
W
W
W
Part code 6005 143