HP StorageWorks P9000 Manual page 141

Table 50 Error codes (part code 6005) (continued)
Part Error Error Message
Code Number
6005 8712 The operation was rejected due to a
'FREEZE' state.
6005 8713 The port group already exists on the
specified port.
6005 8714 An internal error occurred.
6005 8715 Invalid number of paths.
6005 8717 Invalid Destination Link Address.
6005 8718 The specified logical path already
exists.
6005 8719 Invalid RCU serial number, SSID, Link
Address or Controller ID.
6005 8720 Too many RCUs. (Four RCUs are the
maximum.)
6005 8721 Path not completely established.
6005 8722 Failure during path creation.
Recommended Action
If this was a path operation
retry after the problem has
been fixed.
If this was a pair operation,
retry after the paths have
been recovered. Two ways
to recover paths are:
(a) Execute ESTPATH from
the host console, or
(b) First delete the path(s)
from the SVP, then re-add
them.
The port type could not be
changed because the port
group was set in the
specified package. Delete
the group setting, then
change the port type.
Please contact HP Technical
Support.
The specified number of
paths is not within the
acceptable path range of 0
to 4. Verify the number of
paths and retry the
operation.
The specified logical
address must be either 00
or 01. Check the logical
address and retry the
operation.
Check all existing logical
path addresses, and specify
another link address or port.
Check the serial number,
SSID, link address and
controller ID of the RCU, and
set the correct value. Then
retry the operation. If the
same error occurs, please
contact HP Technical
Support.
A maximum of four RCUs
are permitted, and that
many already exist.
Check the path connections
between the MCU and the
RCU, then retry the
operation.
Check the path connections
between the MCU and the
RCU, then retry the
operation.
Severity Level
W
W
E
W
W
W
W
W
W
W
Part code 6005 141