Fcipledtest - Brocade Communications Systems 8 Command Reference Manual

fcipLedTest

Exercises the GbE port LEDS on the Brocade 7800 and FX8-24.
Synopsis fcipledtest [slot | all]
Description Use this command to exercise the GbE port LEDs on the Brocade 7800 and FX8-24. This test cycles
through the port LEDs by lighting GREEN and then flashing GREEN on all ports for 3 seconds. As
the test continues the ports turn AMBER and then flashing AMBER for 3 seconds. The LEDs turn off
when the test has finished.
You must disable the switch before running this command.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
slot
all
Examples To test the LEDs on slot 4 of Brocade DCX with an FX8-24 blade.
See Also ceeportLedTest, portLedTest, switchDisable, switchEnable
Fabric OS Command Reference
53-1001764-02
Tests all GbE ports in the specified slot. This operand is optional; if omitted,
all GbE ports are tested.This operand is valid only on chassis-based
platforms.
Tests all ports on the switch.
switch:admin> fcipledtest 4
PASSED.
2
fcipLedTest
251