Ethernet Networks On Omnicore - ABB OmniCore V250XT Type B Product Manual

3.5.8 Ethernet networks on OmniCore

Network segment overview
The Ethernet networks used by OmniCore are distributed into the following
segments:
Network segment
Private Network
ABB Connect Network
Public Network
I/O Network
Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
Controller ports
DEV
MGMT (Management)
TPU
ABB Connect
WAN 1
WAN 2
LAN
© Copyright 2023-2023 ABB. All rights reserved.
3 Installation and commissioning
3.5.8 Ethernet networks on OmniCore
Usage
Process equipment local to this specific robot.
ABB service personnel in close proximity to the
controller, with a single client connected to the
controller.
Note
The management port shall never be used for
more than one client at a time. ABB Robotics
assumes no responsibility for any errors/hazards
that may appear when more than one client is
used.
FlexPendant connection.
ABB Connect connection.
Public/factory network.
Intended for connecting the robot controller to a
factory wide industrial network.
Intended for connecting the robot controller to a
factory wide industrial network isolated from
WAN.
91