ABB OmniCore V250XT Type B Product Manual page 265

Refitting the drive unit
Refitting the drive unit
1
2
3
Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
Action
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
Position the drive unit on the lower guid-
ing pin on the mounting plate, and then
tip the unit upwards against the upper
guiding pin. Secure the screws.
© Copyright 2023-2023 ABB. All rights reserved.
5.2.13 Replacing the drive unit
Note/Illustration
Location of wrist strap button:
xx2200001817
Screws: Torx pan head screw M4x8 (4 pcs)
Tightening torque: 2 Nm
xx2100000338
Continues on next page
5 Repair
Continued
265