ABB OmniCore V250XT Type B Product Manual page 299

Removing the HMI signal connector
1
2
3
4
Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
5.3.3 Replacing the HMI signal (FlexPendant) connector
Action
Cut the cable ties and remove the cables
out from the clips in the cabinet carefully.
Note
Make records about the sequence that
cables are removed. The cables need to
be installed in the same position.
Disconnect all connectors from the unit
to be replaced.
Remove the screws.
Remove the cover plate.
© Copyright 2023-2023 ABB. All rights reserved.
Note/Illustration
xx2100000830
xx2100000831
Continues on next page
5 Repair
Continued
299