ABB OmniCore V250XT Type B Product Manual page 298

5 Repair
5.3.3 Replacing the HMI signal (FlexPendant) connector
Continued
Required tools and equipment
Equipment
Standard toolkit
ESD protective wrist band
Required documents
Document
Circuit diagram - OmniCore
V250XT, rev 04 or later
Removing the HMI signal connector
Preparations
1
2
3
Continues on next page
298
Action
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
Open the door.
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
© Copyright 2023-2023 ABB. All rights reserved.
Article number Note
- Content is defined in section
Standard toolkit for controller on
page
-
Article number Note
3HAC074000-008
Note/Illustration
Opening the door on page
Location of wrist strap button:
xx2200001817
Product manual - OmniCore V250XT Type B
426.
184.
3HAC087112-001 Revision: A