ABB OmniCore V250XT Type B Product Manual page 236

5 Repair
5.2.8 Replacing the main computer
Continued
5
Concluding procedure
1
2
3
Restoring the hardware settings
The controller hardware settings include information such as controller type and
serial number. When the main computer has been replaced, the serial number
must be restored before any software can be installed, or any licences can be
imported.
1
2
3
4
Continues on next page
236
Action
Apply cable ties and suitable cable pro-
tection to ensure that the cables may not
be damaged by the door.
Action
Close the door.
Restore the hardware settings.
Perform the function tests to verify that
the safety features work properly, see
Function tests on page
Note
When replacing the computer and logic unit, both the serial number and licences
are lost. The serial number must be restored as described below. Licences
however, can either be restored automatically when the RobotWare system is
installed, or manually through Manage Licences in RobotWare Installation
Utilities.
Action
Download the hardware information file
(hwsettings.rsf) from MyABB, or from a
previous system backup.
Access the RobotWare Installation Utilit-
ies.
Tap Advanced, and then Restore Hard-
ware Settings.
The Restore Hardware Settings window
is displayed.
Follow the instructions and tap Next to
proceed.
© Copyright 2023-2023 ABB. All rights reserved.
Note/Illustration
Note/Illustration
Closing the door on page
Restoring the hardware settings on page
173.
Note/Illustration
xx1900000110
Product manual - OmniCore V250XT Type B
185.
236.
3HAC087112-001 Revision: A