Connecting The Ethernet/Ip Network - ABB Scalable I/O Applications Manual

4.2 Connecting the EtherNet/IP network

Connecting the EtherNet/IP network
The I/O devices are based on the EtherNet/IP communication protocol but does
not require any additional RobotWare options or hardware options to be connected
to the robot controller. In this standard configuration, the devices should be
connected to the Private Network to gain the advantages with Plug & Produce.
When using the RobotWare options 3024-1 EtherNet/IP Scanner or 3024-2
EtherNet/IP Adapter more configuration possibilities are available. For more
information see Application manual - EtherNet/IP Scanner/Adapter.
For more information about network connections on OmniCore, see Operating
manual - Integrator's guide OmniCore.
Application manual - Scalable I/O
3HAC070208-001 Revision: F
© Copyright 2019-2022 ABB. All rights reserved.
4 Software commissioning
4.2 Connecting the EtherNet/IP network
57