ABB OmniCore V250XT Type B Product Manual page 316

5 Repair
5.3.5 Replacing the Ethernet outlet connector with cable
Continued
Refitting the Ethernet outlet connector with cable
Refitting the Ethernet outlet connector with cable
1
2
3
4
5
6
Concluding procedure
1
Continues on next page
316
Action
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
Insert the Ethernet outlet connector with
cable into the cover from inner side of
the cabinet.
Secure it with the locking ring.
Reconnect any connectors disconnected
at removal.
Secure the Ethernet outlet connector with
cables with the clips on the cabinet.
Tip
Use the same position as from removing
the harness ETH outlet with cable.
Action
Close the door.
© Copyright 2023-2023 ABB. All rights reserved.
Note/Illustration
xx2100000852
Note/Illustration
Closing the door on page
Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
185.