ABB OmniCore V250XT Type B Product Manual page 263

Required spare parts
Spare part
Drive unit, High Voltage
Harness DC-bus
Harness 24_SYS_DRV
Ethernet harness
Harness 24_BRAKE
Harness CTRL_FB
Required tools and equipment
Equipment
Standard toolkit
ESD protective wrist band
Required documents
Document
Circuit diagram - OmniCore
V250XT, rev 04 or later
Removing the drive unit
Preparations
1
2
Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
WARNING
Do not touch the drive unit when the DC-BUS High Voltage LED is on.
There is residual voltage in the drive unit even if the main switch is in the OFF
position.
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore V250XT Type B via myABB Business Portal,
www.abb.com/myABB.
Action
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
Open the door.
© Copyright 2023-2023 ABB. All rights reserved.
5.2.13 Replacing the drive unit
Article number Note
3HAC064590-001 DSQC3062
3HAC065225-001 Harness A1.X4 - T4.X5
3HAC081734-001 Harness A1.X5 - T4.X1
3HAC081970-001 Harness A1.X12 - T4.X3
3HAC081731-001 Harness A1.X11 - T4.X13
3HAC082738-001 Harness A1.X2 - T4.X17
Article number Note
- Content is defined in section
Standard toolkit for controller on
page
-
Article number Note
3HAC074000-008
Note/Illustration
Opening the door on page
5 Repair
Continued
426.
184.
Continues on next page
263