Table of Contents
Advertisement
Description
LINK
RF, signal
strength status
LEDs
Reset pin hole
Required test equipment
Equipment needed for troubleshooting:
Equipment
Multimeter
Insulating gloves
Preparations
1
2
3
Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
7.3.8 Troubleshooting the 3G Connected Services gateway
Significance
For the connected services Wi-Fi, an orange LED indicator, externally
visible on the front, indicates the status of the Wi-Fi connection.
Orange:
•
ON, flashing: Wi-Fi transceiver on, searching network.
•
ON, solid: Wi-Fi transceiver on and connected to network.
Three (3) LEDs indicating the Wi-Fi or 3G signal level.
•
ON: The unit is connected to the network and working ok.
•
OFF: Problem with connector, antenna, or sim card.
The reset pin hole can be used as follows:
•
Short press (less than 5s): The module will reboot to reinitiate
communication.
•
Long press (more than 5s): The module will be reset to factory
status before restarting.
Action
Check the FlexPendant for errors and warnings.
Power the controller off. Wait one minute, power the controller on.
Wait 30-60 seconds after power-on.
Make sure that the control system power is in run-time mode.
© Copyright 2023-2023 ABB. All rights reserved.
7 Troubleshooting
Note
Continues on next page
Continued
399
Advertisement
Table of Contents
Troubleshooting
