ABB OmniCore V400XT Product Manual page 89

Attaching the FlexPendant
Attach the connector to the controller and tighten the locking ring or screws.
xx1900000975
Product manual - OmniCore V400XT
3HAC081697-001 Revision: A
When detached, the FlexPendant will shut down.
Note
If the FlexPendant is not detached within 30 seconds, the process for
detach of the FlexPendant is aborted.
WARNING
If the FlexPendant is detached after the 30 seconds countdown has passed,
the controller will enter emergency stop state.
CAUTION
Always inspect the connector for dirt or damage before attaching. Clean or replace
any damaged parts.
CAUTION
Make sure that the emergency stop device is not pressed in before attaching the
FlexPendant.
© Copyright 2022-2023 ABB. All rights reserved.
3 Installation and commissioning
3.5.7 Detaching and attaching a FlexPendant
Continued
89