Hanging the front part of the FlexPendant holder with screws (Vertically)
Use this procedure to hang the front part of the FlexPendant holder to the desired
place.
1
2
3
4
5
Product manual - OmniCore V400XT
3HAC081697-001 Revision: A
Action
Remove the four screws.
Separate the rear part from the FlexPend-
ant holder.
Clean the surface and make sure it is dry.
Remove the protective liner from the
tape.
Press the holder onto the desired place.
© Copyright 2022-2023 ABB. All rights reserved.
3 Installation and commissioning
3.4.3 Mounting the FlexPendant holder
Note/illustration
xx2000002356
xx2000002357
Continues on next page
Continued
65