ABB OmniCore V400XT Product Manual page 296

5 Repair
5.3.3 Replacing the HMI signal (FlexPendant) connector
Continued
3
Removing the HMI signal connector
1
2
Continues on next page
296
Action
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
Action
Cut the cable ties and remove the cables
out from the clips in the cabinet carefully.
Note
Make records about the sequence that
cables are removed. The cables need to
be installed in the same position.
Disconnect all connectors from the unit
to be replaced.
© Copyright 2022-2023 ABB. All rights reserved.
Note/Illustration
Location of wrist strap button:
xx2300001842
Note/Illustration
Product manual - OmniCore V400XT
3HAC081697-001 Revision: A