ABB OmniCore V400XT Product Manual page 221

4
5
Reconnecting the antenna
1
2
Product manual - OmniCore V400XT
3HAC081697-001 Revision: A
Action
Reconnect the free ends of the 24V ad-
apter harness:
• Wire K7-W201 to the 24V (V+)
connection on the Connected
Services gateway.
• Wire K7-W202 to the 0V (V-) con-
nection on the Connected Ser-
vices gateway.
Reconnect any connectors disconnected
at removal.
Action
Place the magnet part of the antenna on
the outside of the cabinet.
Follow the cable routing recorded during
the disassembly when you reconnect the
antenna cable.
© Copyright 2022-2023 ABB. All rights reserved.
5.2.5 Replacing the 4G Connected Services gateway
Note/Illustration
xx2300000753
Note/Illustration
Note
The operating conditions must be such that
there is a minimum separation distance of
20 cm between the dedicated antenna and
nearby persons.
Note
The Connected Services antenna is installed
by the customer, and the cable routing can
therefore differ.
5 Repair
Continued
Continues on next page
221