ABB OmniCore V400XT Product Manual page 234

5 Repair
5.2.8 Replacing the main computer
Continued
Concluding procedure
1
2
3
Restoring the hardware settings
The controller hardware settings include information such as controller type and
serial number. When the main computer has been replaced, the serial number
must be restored before any software can be installed, or any licences can be
imported.
1
2
3
4
5
Continues on next page
234
Action
Close the door.
Restore the hardware settings.
Perform the function tests to verify that
the safety features work properly, see
Function tests on page
Note
When replacing the computer and logic unit, both the serial number and licences
are lost. The serial number must be restored as described below. Licences
however, can either be restored automatically when the RobotWare system is
installed, or manually through Manage Licences in RobotWare Installation
Utilities.
Action
Download the hardware information file
(hwsettings.rsf) from MyABB, or from a
previous system backup.
Access the RobotWare Installation Utilit-
ies.
Tap Advanced, and then Restore Hard-
ware Settings.
The Restore Hardware Settings window
is displayed.
Follow the instructions and tap Next to
proceed.
Carefully read the information and then
check all boxes to confirm that you agree
with the ABB conditions. Tap Next to
proceed.
© Copyright 2022-2023 ABB. All rights reserved.
Note/Illustration
Closing the door on page
Restoring the hardware settings on page
171.
Note/Illustration
xx1900000110
Product manual - OmniCore V400XT
183.
234.
3HAC081697-001 Revision: A