ABB OmniCore V400XT Product Manual page 298

5 Repair
5.3.3 Replacing the HMI signal (FlexPendant) connector
Continued
5
6
7
Refitting the HMI signal connector
Refitting the HMI signal connector
1
2
Continues on next page
298
Action
Remove the attachment screws on the
door.
Push the HMI signal connector into the
cabinet.
Take out the HMI signal connector.
Action
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
© Copyright 2022-2023 ABB. All rights reserved.
Note/Illustration
xx2100000832
Note/Illustration
Location of wrist strap button:
xx2300001842
Product manual - OmniCore V400XT
3HAC081697-001 Revision: A