ABB OmniCore V400XT Product Manual page 211

3
Disconnecting the antenna
1
2
3
4
Product manual - OmniCore V400XT
3HAC081697-001 Revision: A
Action
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
Action
Record the cable routing when you re-
move the antenna cable from the cabinet.
Disconnect the antenna cable from the
Connected Services gateway by rotating
the connector.
Remove any cable ties and protection.
Pull the cable out through the cable
grommet.
© Copyright 2022-2023 ABB. All rights reserved.
5.2.4 Replacing the 3G Connected Services gateway
Note/Illustration
Location of wrist strap button:
xx2300001842
Note/Illustration
Note
The Connected Services antenna is installed
by the customer, and the cable routing can
therefore differ.
xx2300001642
xx2200001973
5 Repair
Continued
Continues on next page
211