ABB OmniCore V400XT Product Manual page 63

5
Mounting the FlexPendant holder onto a flat surface (Horizontally)
Use this procedure to mount the FlexPendant holder onto a flat surface, like the
top of the controller or a desktop.
1
2
Product manual - OmniCore V400XT
3HAC081697-001 Revision: A
Action
Refit the rear part and secure with the
screws.
Action
Clean the surface and make sure it is dry.
Remove the protective liner from the
tape.
© Copyright 2022-2023 ABB. All rights reserved.
3 Installation and commissioning
3.4.3 Mounting the FlexPendant holder
Note/illustration
Screws: BN33 Phillips pan head tapping
screw ST3.5x16 (4 pcs)
Tightening torque: 9.4 Nm-12.2 Nm
xx2000002356
Note/illustration
xx2000002352
Continues on next page
Continued
63