ABB OmniCore V400XT Product Manual page 282

5 Repair
5.2.18 Replacing the break resistor bleeder
Continued
Spare part
Break resistor bleeder assembly
Required tools and equipment
Equipment
Standard toolkit
ESD protective wrist band
Required documents
Document
Circuit diagram - OmniCore
V400XT
Removing the break resistor bleeder
Preparations
1
2
3
4
Removing the break resistor bleeder
1
Continues on next page
282
Action
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
Remove the rear cover of the controller.
Open the door.
Action
Remove the cable ties.
© Copyright 2022-2023 ABB. All rights reserved.
Article number Note
3HAC081951-001
Article number Note
- Content is defined in section
Standard toolkit for controller on
page
-
Article number Note
3HAC082020-008
Note/Illustration
Location of wrist strap button:
xx2300001842
Removing the rear cover on page
Opening the door on page
Note/Illustration
Product manual - OmniCore V400XT
424.
184.
182.
3HAC081697-001 Revision: A