Table of Contents
Advertisement
Short thread cutter
17.2 Setting the thread-pulling knife
Proper setting
When the thread-pulling knife (1) is at rest, the distance between the
highest point of the control cam (7) and the roller (5) is 0.1 mm
The control cam (7) makes contact with the clamping ring (6).
The marking (3) on the thread-pulling knife (1) is adjacent to the cutting
edge of the counter blade (2)
The knife carrier (4) must have no axial play, but still run smoothly
Fig. 68: Setting the thread-pulling knife
(1) - Thread-pulling knife
(2) - Counter blade
(3) - Marking
(4) - Knife carrier
(5) - Roller
To set the thread-pulling knife:
1. Loosen all 4 screws on the clamping ring (6) and push the clamping
2. Tighten all 4 screws on the clamping ring (6).
3. Loosen both threaded pins on the control cam (7).
4. Turn the lever (8) as far as it will go against the screw (10).
5. Set the distance between the roller (5) and the highest point of the
6. Tighten both threaded pins on the control cam (7).
7. Loosen the clamping screw (9) on the lever (8).
8. Turn the thread-pulling knife (1) until the marking (3) on the cutting
9. Tighten the clamping screw (9).
Service Instructions 1767 - 00.0 - 12/2016
①
②
③
ring (6) toward the hook bearing.
control cam (7) to 0.1 mm.
edge of the counter blade (2) is adjacent to it.
Take care to ensure that there is no axial play.
④ ⑤ ⑥
(6) - Clamping ring
(7) - Control cam
(8) - Lever
(9) - Clamping screw
(10) - Screw
⑩
⑨
⑧
⑦
85
Advertisement
Table of Contents
