Setting The Outfeed Roller Path - Dürkopp Adler 806N-111 Operating Instructions Manual

Programming
Variant 2
With this variant the stack remains in the original position during stacking.
This variant is recommended when the material is very slippery. The static
loading reduces the danger of the sewn products slipping down after
stacking.
To activate stacker variant 2:
1. Press the button Stacker 2
 The button is highlighted in green.
 After the next sewing cycle the machine stores the finished sewn
2. Press the Stacker 2 button
 The button is no longer highlighted in green.
 After the next sewing cycle the machine does not store the finished
This setting remains stored after switching off the machine, after loading
a different seam program or after an EMERGENCY STOP.

5.6.8 Setting the outfeed roller path

This allows you to set the path over which the finished sewn product is to
be rolled before being ejected from the sewing area. Three outfeed roller
variants can be set:
To set the outfeed roller path:
1. Press the Outfeed roller path button
 The selection window Outfeed roller path opens.
Operating Instructions 806N-111/806N-121 - 04.0 - 12/2020
product using the stacker.
sewn product using the stacker.
Value
0 The outfeed roller is switched off and does not roll.
1 The outfeed roller is switched on and only rolls the finished sewn prod-
ucts for ejection from the sewing area.
2-10 The outfeed roller is switched on and first slowly rolls the finished
sewn products a specific distance out of the sewing area. The outfeed
roller then rolls the finished sewn products for ejection from the sewing
area.
.
again to deactivate this mode.
Function
.
91