Updating Snc Firmware; Saving A Configuration File; Loading A Configuration File - ADIC Scalar 100 User Manual

Updating SNC Firmware

1. From the Hyper Terminal window, at the SN60023 > command prompt, type rz
and then press the Enter key.
2. From the HyperTerminal window select Transfer and Send File.
3. From the Send File dialog enter the path and filename where the firmware file is
located or click the Browse button and navigate to it. In the Protocol field, select
Zmodem and click the Send button.
4. It will take several minutes for the file to be transferred. The Zmodem file send dialog
will display the current status and it will close automatically when the file transfer has
completed.
5. Wait for the "Firmware Update Complete" status message to be displayed on the
service terminal indicating successful completion. You must reboot the SNC for the
update to take effect.
If HyperTerminal reports an error, try to send the file again. If the SNC reports an error,
make a note of the error code and see the "Zmodem Status Code Table"on page 167 for
further information.

Saving a Configuration File

1. From the HyperTerminal window enter sz "config.cfg" <Enter>. The
filename "config.cfg" is shown here as an example. You can specify a different
filename but it must be in quotes, 8 characters or less and end in .cfg.
2. From the HyperTerminal window select Transfer and Receive File.
3. From the Receive File dialog enter the path to the folder where you want to save
the file or click the Browse button and navigate to it. For the Receiving protocol
select Zmodem and press the Receive button.
4. Wait for the "Configuration Download Complete" status message to be displayed on
the service terminal indicating successful completion.
If HyperTerminal reports an error, try to receive the file again. If the SNC reports an error,
make a note of the error code and see the "Zmodem Status Code Table" for further infor-
mation.

Loading a Configuration File

1. From the Hyper Terminal window, at the SN60023 > command prompt, type rz
and then press the Enter key.
page 166
Updating Firmware and Configurations