ADIC Scalar 100 User Manual page 225

that the system administrator must reassign SFM access permissions between the hosts
and LUNs.
This may be required when a host system has a limited number of logical units that may be
supported, and changing devices on the SNC has caused the logical unit numbers to
increase beyond the host's supported level.
SN60023 > mapRebuildDatabase
This command will clear the Persistent Device Map.
Existing SFM Access Settings may become invalid and
should be cleared because LUN assignments may change!
These changes will take effect when the SNC is rebooted.
Do you want to clear the Device Map? (y or n) y
Removing the Persistent Device Map
Device Map Cleared - Do you want to clear SFM Access Settings?
(y or n) y
SFM Access Cleared - Reboot SNC (y or n) y== reboot
SN60023 >
mapShowDatabase
The SNC maintains a database of attached devices, to insure that each time a host attaches
to it, the target devices are seen at a consistent address. The database will list not only the
devices presently connected, but also devices that have previously been connected. If a
previously attached device is later reattached, it will be assigned back to its previous
address. Use the mapShowDatabase command to display the persistent device map
table.
SN60023 > mapShowDatabase
devId Type Chan tId tLun UID
-----------------------------------------------
000 SNA 127 127 127 00000060:450d00c0
001 SCSI 001 003 000 00000060:450d00c0
002 SCSI 001 002 000 00000060:450d00c0
003 SCSI 001 001 000 00000060:450d00c0
004 SCSI 002 002 000 00000060:450d00c0
005 SCSI 002 000 000 00000060:450d00c0
006 SCSI 002 006 000 00000060:450d00c0
007 SCSI 002 009 000 00000060:450d00c0
008 SCSI 002 002 001 00000060:450d00c0
009 SCSI 002 005 000 00000060:450d00c0
010 SCSI 002 005 001 00000060:450d00c0
011 SCSI 001 000 000 00000060:450d00c0
012 SCSI 001 006 000 00000060:450d00c0
value = 0 = 0x0
SN60023 >
devId The index of the device in the database.
page 211
mapShowDatabase