ADIC Scalar 100 User Manual page 222

Table B-3: Event Log Levels
1
2
3
The following is an example dump after a typical boot sequence with four target devices
added (one additional one is shown; that is the Command and Control LUN of the SNC
itself).
SN60023 > loggerDumpCurrent 1
*** Dumping 9 (1010 through 1018) current records with level >=
0 ***
000001 0d:00h:00m:05s:56t -- NOTICE: CS and LOGGING STARTED
000002 0d:00h:00m:07s:19t -- FCAL 1: LIP occurred
000003 0d:00h:00m:07s:19t -- FCAL 1: Loop up
000004 0d:00h:00m:07s:22t -- SCSI 1: Bus RESET
000005 0d:00h:00m:07s:22t -- SCSI 2: Bus RESET
000006 0d:00h:00m:07s:22t -- Target device added: index 0,
handle 0xc0ec2600
000007 0d:00h:00m:08s:18t -- Target device added: index 9,
handle 0xc1f9e090
000008 0d:00h:00m:08s:18t -- Target device added: index 10,
handle 0xc0ad2590
000009 0d:00h:00m:08s:28t -- SCSI 2: New Device at Id 6, Lun 0
value = 0 = 0x0
SN60023 >
ls or ll
The SNC contains a file system in its flash memory. Use the ls command to display the
files as shown below.
SN60023 >
license.dat
sna.rc
vxWorks.st
value = 0 = 0x0
SN60023 >
To obtain detailed information about the file, use the ll command instead.
page 208
Notice Conditions that should always be
reported, such as temperature alarms
and device removals
Warning Events that might result in a later
problem
Information Events that are not errors or
warnings
ls or ll