ADIC Scalar 100 User Manual page 206

After the command executes, the number displayed as a value indicates the port mode as
follows:
The following example shows how the connection type is displayed when Fibre Channel
port 1 is specified and the port mode is Private Target.
SN6002 >fcPortModeGet 1
value = 1 = 0x1
SN6002 >
fcPortModeSet [port],[mode]
The fcPortModeSet command sets the mode for the specified Fibre Channel port. See
also the fcPortModeGet command.
The default port mode is Public Target. Consequently, if attached to a Fabric device the
SNC will register as a Target with the name server. If the port mode is Private Target,
the SNC does not register with the name server and the Fabric device will not recognize
the SNC as a Target.
The port must be in Initiator mode if you want the SNC to scan for target devices on the
port. When the port is in Private Initiator mode, the SNC only scans for devices on the
page 192
Parameter Value
2
Value
1 Private Target
2 Private Initiator
3 Private Target and Initiator
17 Public Target
18 Public Initiator
19 Public Target and Initiator
Attention: You must issue the fcRestart command or reboot the SNC for
the new setting to take effect. See the fcRestart command for further
information.
Meaning
The SNC Connection labeled FC2
Port Mode
fcPortModeSet [port],[mode]