ADIC Scalar 100 User Manual page 230

If the ridtag command is entered with a string, that string becomes the RID tag
recorded for the unit.
SN60023 > ridtag "12D345677"
*** value = 0 = 0x0
If a string is not entered, the existing RID tag is displayed.
SN60023 > ridtag
RID Tag = 12D345677
value = 0 = 0x0
SN60023 >
On original equipment, the RID tag will be blank.
rm
To remove a file, use the rm command and specify the file name in quotes:
SN60023 > rm "file.ext"
route
The route utilities maintain a route file, nvfs:/mgmt/route, which is used at
system startup to initialize the network routing table. Each route entry is a single line of
the format:
destination:gateway
where
An IP address is a text string in standard IP Address format (i.e., 10.0.0.2). A host or
gateway name must be listed in the hosts file.
Here is an example of the contents of the route file.
socrates:bruno
10.0.0:bruno
The first line instructs the system to reach the host "socrates" by directing the IP packets
to the host "bruno". The second example shows how all traffic for the subnet 10.0.0
(implied netmask is 255.255.255.0) is sent to the host "bruno" for forwarding. By default,
no routes are defined in the route file.
page 216
destination is an IP address (for a subnet or host) or the name of a
host that is described in the hosts file.
gateway is an IP address or the name of a gateway to a host. The
gateway must be a device on the local subnet.
rm