setFcFrameSize [channel],[size]
Set the frame size for a channel using the setFcFrameSize command.
If an invalid size is set, then the frame size of 2048 will be used.
SN60023 > setFCFrameSize 1,2048
value = 2048 = 0x800
SN60023 >
setFcHardId [channel],[id]
Set the Hard AL_PA for a channel using the setFcHardId command.
FC Number
ID Number
The ID settings 0 to 125, inclusive, are valid IDs. [255] requests the Soft ID method. If an
invalid id is requested, then the Soft ID method will be used.
SN60023 > setFcHardId 1,1
value = 0 = 0x0
SN60023 >
setHost [port],"OS"
The setHost command sets the operating system type for the specified SAN interface.
This provides some customization in the way the SNC is presented to the particular
page 224
Parameter
SAN Channel Number
Frame Size
Attention: You must reboot the SNC after executing this command for the
new setting to take effect.
Parameter
1 or 2
0 to 125
255
Attention: You must reboot the SNC after executing this command for the
new setting to take effect
Value
1 - 2
512,1024, or 2048
Value
Use Soft ID method
Meaning
setFcFrameSize [channel],[size]