Ethernet; Service Port; Led Indicators; Figure 1-3: Leds - ADIC Scalar 100 User Manual

• The unit provides four SCSI-3 VHDCI connectors for maximum mechanical
reliability.
The SCSI interfaces are compliant with the following SCSI specifications:
• ANSI T10/1071D Rev. 6, SCSI-3 Fast-20
• ANSI T10/375D Rev. 10t, SCSI-2
• ANSI T10/1142D Rev 20b, SCSI-3 Parallel Interface-2

Ethernet

The 10/100 Base-T Ethernet port has an RJ-45 connector for out-of-band management. It
can be connected to a network hub, switch, or router using an unshielded twisted-pair
Ethernet cable. The Ethernet port complies with the IEEE 802.3 specification.

Service Port

The service port is an RS-232 connection with a 9-pin D-shell connector (DTE). It
connects to the host serial port with a 9-pin to 9-pin null-modem cable. It is compatible
with serial ports on personal computers.
The service port is used for local service and diagnostics when you use a terminal session
to access the shell interface.
The service port is configured at:
• 19,200 Baud
• 8 data bits
• No parity
• One stop-bit
• Hardware Flow Control or Xon/Xoff

LED Indicators

The User panel of the SNC provides LEDs that indicate the status and activity of the SNC
and its interfaces.

Figure 1-3: LEDs

page 14
Hardware Product Description and Features