fcFibreSpeedSet [port],[speed]
The fcFibreSpeedSet command sets the Fibre Channel port speed to 1 Gb/sec or 2
Gb/sec for a Fibre Channel port. The port can also be set to autorange, as in the example
below.
Parameter
Port
Speed
SN60023 > fcFibreSpeedSet 1,0
value = 0 = 0x0
SN6002 >
fcGbicShow [port]
The fcGbicShow command displays the GBIC information for each installed GBIC.
Specifying the port number is optional.
Port
page 190
Value
1
The SNC Connection labeled FC1
2
The SNC Connection labeled FC2
0
Autorange
1
1 Gb/sec
2
2 Gb/sec
Attention: You must issue the fcRestart command or reboot the SNC for
the new setting to take effect. The initiator and the device must both be
capable of the selected speed. See the fcRestart command for further
information.
Parameter
Value
1
2
Meaning
Meaning
The SNC Connection labeled FC1
The SNC Connection labeled FC2
fcFibreSpeedSet [port],[speed]