ADIC Scalar 100 User Manual page 227

mapWinnowDatabase
Occasionally, you may want to eliminate inactive entries from the database. The
mapWinnowDatabase command reduces the database to only the devices presently
attached. The address mapping of the current devices will not be altered.
SN60023 > mapWinnowDatabase
0xc0ac8340 (tShell): Wrote 4 device maps to file 'nvfs:config/
device.map'
value = 4 = 0x4
SN60023 >
mbufShow
The mbufShow command displays statistics about the distribution of mbufs on the
Ethernet network. Interpreting these statistics requires detailed knowledge of Internet
networking protocols. This information may be useful to the LAN administrator.
SN60023 > mbufShow
type number
--------- ------
FREE :
DATA :
HEADER :
SOCKET :
PCB :
RTABLE :
HTABLE :
ATABLE :
SONAME :
ZOMBIE :
SOOPTS :
FTABLE :
RIGHTS :
IFADDR :
TOTAL :
number of mbufs: 40
number of clusters: 4
number of interface pages: 0
number of free clusters: 4
number of times failed to find space: 0
number of times waited for space: 0
number of times drained protocols for space: 0
mapWinnowDatabase
Attention: Winnowing the database might cause unattached devices to
change addresses unpredictably if they are reattached. Use this command
only when you are sure that the devices you are interested in are connected
and available to the SNC. You must reboot the SNC after executing this
command for the new setting to take effect.
23
0
1
0
11
3
0
0
0
0
0
0
0
2
40
page 213