fcConnTypeSet [port],[connection]
The fcConnTypeSet command is used to set the type of connection for a Fibre Channel
port. See also the fcConnTypeGet command
Parameter
Port
Connection Type
The following example shows how to set Fibre Channel port 1 connection type to point-to-
point.
SN60023 > fcConnTypeSet 1,1
value = 0 = 0x0
SN60023 >
fcFibreSpeedGet [port]
The fcFibreSpeedGet command displays the requested speed of the Fibre Channel
port. The actual speed can be viewed in the output of the fcShow command. The example
below shows that Fibre Channel port 1 has a maximum speed of 1 Gb/sec.
SN60023 > fcFibreSpeedGet 1
value = 1= 0x1
SN60023 >
port
value =
fcConnTypeSet [port],[connection]
Value
1
2
0
1
2
Attention: You must issue the fcRestart command or reboot the SNC for
the new setting to take effect. See the fcRestart command for further
information.
Parameter
Value
1
2
0
1
2
The SNC Connection labeled FC1
The SNC Connection labeled FC2
Loop
Point-to-Point
Loop Preferred
Meaning
The SNC Connection labeled FC1
The SNC Connection labeled FC2
Speed is set to Autorange
Speed is set to 1 Gb/sec
Speed is set to 2 Gb/sec
Meaning
page 189