Table 2-1: Pre-Installation Steps
Step
7
8
Pre-installation Checklist
Customer Action or Decision
Decide on network parameters.
Ethernet port configuration
decisions:
Static IP address____________
Netmask (if required)_________
User-defined SNC name
(optional)__________________
If the SNC is not on the same TCP/
IP subnet as the server*, assign the
default network gateway address
and/or route table entries:
________________________
*'Server' in this context, means the
computer used for the ADIC
Management Console server
application.
Attention: Save this configuration
information for future reference.
Run the Ethernet cable from the
server (the computer that is
designated to run the ADIC
Management Console Server
software) to the network hub.
Comments and References
Obtain the network parameters from your
network administrator.
Attention: Use of incorrect network
parameters can cause problems on the
Ethernet network.
The default network name is the unit's
serial number. If you choose a different
name, it becomes the prompt displayed on
the service terminal. Choosing a different
name may be useful if you have more than
one SNC . To change the name, use the
"hostNameSet" command on page
203.
None.
page 25