ADIC Scalar 100 User Manual page 208

SN60023 > fcRestart 1
value = 0 = 0x0:
Restart of FC Channel 1 succeeded
In order to get the command prompt (e.g. SN60023 >) to show after you have executed
the fcRestart command, you will need to press the Enter key.
fcShow [level]
The fcShow command displays the channel status for each Fibre Channel interface.
Level
0 or
<blank>
1
2
SN600032 > fcShow
------------------Fibre Channel Controllers-----------------------
Ctlr : PCI Addr : ISP
xt. : Link
Id : Bs Dv Fn : Type
IFO : Speed
------------------------------------------------------------------
1 : 00 07 00 : 2300
one : 1 Gbps
2 : 00 08 00 : 2300
one : 2 Gbps
------------------------------------------------------------------------------
value = 95 = 0x5f = '_'
SN600032 >
page 194
sets the verbosity level to the display in the
example below
displays the information displayed below, and
appends a break-out for each channel that includes
Node Type, Node Name, Port Name and Port ID
displays the information included at levels 0 and
1, and appends loop ID link stats
: Firmware
: State
: Sync Lost
: Sync Lost
Ctlr Id Indicates the Port Number for this interface.
PCI Addr The PCI address of the interface, showing bus, device id,
and function number.
ISP Type The type of Fibre Channel Controller.
Firmware State The current state of the interface as reported by the Fibre
Channel controller. Firmware states are listed below.
Configuration Wait
Waiting for AL_PA
Meaning
: Firmware : Loop :
: Version : ID : Attached : Mode : F
: 3.00.25 : None :
: 3.00.25 : None :
Firmware is not initialized.
Firmware is performing or waiting to
Fabric : Port : E
No : Targ : N
No : Targ : N
fcShow [level]