ADIC Scalar 100 User Manual page 237

scsiTermGet [channel]
The scsiTermGet command displays termination status information for the specified
channel. If no channel is specified, status information is displayed for all SCSI channels.
SN60023 > scsiTermGet
SCSIbus Termination ------- ---------------
SCSI 1 Enabled – default
SCSI 2 Enabled
value = 0 = 0x0
SN60023 >
SN60023 > scsiTermGet 2
SCSIbus Termination ------- ---------------
SCSI 2 Enabled – default
value = 0 = 0x0
SN60023 >
scsiTermSet [channel],[termination]
The scsiTermSet command enables or disables the termination for the SCSI Channel.
scsiTermGet [channel]
Vendor The content of the Vendor ID field from the SCSI
Inquiry Data
Product The content of the Product ID field from the SCSI
Inquiry Data
Rev The content of the Revision ID field from the SCSI
Inquiry Data
Sync/Off The negotiated synchronous transfer period and offset.
The period is the negotiated transfer period. Multiply the
period times 4 nanoseconds to determine the actual
period (exception: if the period is negotiated to 12, then
50ns. is used). The offset indicates the REQ/ACK offset
that was negotiated. A zero in these fields indicates that
asynchronous transfer is in use.
Width The negotiated transfer width in bits, either 8 or 16.
Parameter
Channel Number
Termination
Value Meaning
1 - 4 Selected Channel
0 Enable Termination
1 Disable Termination
page 223