ADIC Scalar 100 User Manual page 202

ethAddrSet
The ethAddrSet command changes the IP address of the SNC. An IP address is
specified as 4 decimal numbers separated by periods.
SN60023 > ethAddrSet "192.168.1.54"
Host Address set to 192.168.1.54 for Ethernet interface
value = 0 = 0x0
SN60023 >
If a netmask is required, specify it after the IP address in "dotted decimal" form. For
example:
SN60023 > ethAddrSet "10.0.0.2","255.255.0.0"
Inet Mask set to ffff0000 for Ethernet interface
Write complete
Host Address set to 10.0.0.2 for Ethernet interface
value = 0 = 0x0
SN60023 >
fcConnTypeGet [port]
The fcConnTypeGet command is used to display the current setting of a Fibre
Channel port's connection type. See also the fcConnTypeSet command.
Parameter
port
connection type
The following example shows how the connection type is displayed when Fibre Channel
port 1 is specified and its connection type is loop.
SN600012 > fcConnTypeGet 1
value = 0 = 0x0
SN600012 >
page 188
Value
1 The SNC Connection labeled FC1
2 The SNC Connection labeled FC2
0 Loop
1 Point-to-point
2 Loop preferred
Meaning
ethAddrSet