ADIC Scalar 100 User Manual page 196

clearReservation[devId]
The clearReservation command can be used to force-clear a reservation held by a
host for the specified target device. It may be necessary to issue this command if a host
that has a reservation for a shared device was disconnected from the SNC without
properly shutting down the application software that issued the reservation. If this is the
case, other hosts that attempt to access the shared device will repeatedly receive
reservation conflict status from the device. Issuing this command may result in resetting
the target device.
Parameter Value
devId The index of the device (LUN)
SN60023 > clearReservation 4
value = 0 = 0x0
SN60023 >
The above example shows the clearReservation command being used to clear a
reservation on a target device at LUN 4.
cleHelp
The cleHelp command displays a list of the Command Log Event facility commands.
SN60023 > cleHelp
CLE - Command Log Event facility
cleShow <lun> - Displays Logged Events for a specific LUN
cleShowAll - Displays Logged Events for All LUNs
value = 0 = 0x0
SN60023 >
cleShow <LUN>
The cleShow command displays the last 64 Command Log events for a device at the
specified LUN. This log is not maintained for disk devices because the performance
impact is significant. The manufacturer may request the contents of the command log for
diagnostic purposes. Information about interpreting these events is not provided.
cleShowAll
The cleShowAll command performs a cleShow for all LUNs. The manufacturer may
request the contents of the command log for diagnostic purposes. Information about
interpreting these events is not provided.
page 182
clearReservation[devId]