ADIC Scalar 100 User Manual page 267

Unsuccessful Fibre Test 2 (cable not plugged in):
diagmode > fcSlotTest 1
FC 1 [##########] Iterations 37 Errors 37 - FAILED
Fibre Channel Port 1 returns FAILED
value = -1 = 0xffffffff = pNullDmaDesc + 0xfe4ea9f7
scsiChannelTest (x,y)
The SNC must be in diagnostic mode to use this command and a SCSI cable must be
connected between two SCSI channels.
The scsiChannelTest command performs a confidence test on a pair of SCSI
channels. Substitute for x and y the SCSI channel numbers you want to test. Parentheses
are optional. This command can be used to test the SCSI interface or the SCSI cable.
The example below shows the display for a test on SCSI channels 1 and 2.
diagmode > scsiChannelTest (3,4)
SCSI-3 -> SCSI-4 [##########] 10 iterations PASSED
SCSI-4 -> SCSI-3 [##########] 10 iterations PASSED
value = 0 = 0x0
diagmode > scsiChannelTest (1,2)
SCSI-1 -> SCSI-2 [##########] 10 iterations PASSED
SCSI-2 -> SCSI-1 [##########] 10 iterations PASSED
value = 0 = 0x0
The following output is an example of a SCSI port test that was not successful. If your test
was not succesful, return to the MAP that sent you here.
Unsuccessful SCSI Test (cable not plugged in):
diagmode > scsiChannelTest (1,2)
SCSI Initiator Error(s) - STO iUnk
SCSI Initiator Error(s) - STO iUnk
SCSI-1 -> SCSI-2 [SCSI Initiator Error(s) - STO iUnk
ERROR, i = 1 ] 1 iterations FAILURE
SCSI-2 -> SCSI-1 [SCSI Initiator Error(s) - STO iUnk
ERROR, i = 1 ] 1 iterations FAILURE
value = -1 = 0xffffffff = pNullDmaDesc + 0xfe4ea9f7
showBox
The showBox command displays the components present in the SNC using characters to
form a picture of the unit, as viewed from the rear.
Diagnostic Commands
page 253