ADIC Scalar 100 User Manual page 207

local loop. If the port mode is in Public Initiator mode, the SNC also scans for devices
attached to a Fabric.
Port
Mode
SN60023 > fcPortModeSet 1,2
value = 0 = 0x0
SN60023 >
fcRestart [port]
The fcRestart command restarts the specified Fibre Channel port. You typically use
this command to restart the port after changing its configuration settings so that the
changes take effect. Issuing this command is an alternative to rebooting the SNC in order
to make the configuration changes take effect.
Attention: This command interrupts traffic.
Port
The following example shows the display when Fibre Channel port 1 is specified.
fcRestart [port]
Parameter Value
1
2
1
2
3
17
18
19
Attention: You must issue the fcRestart command or reboot the SNC for
the new setting to take effect. See the fcRestart command for further
information.
Parameter Value
1
2
Meaning
The SNC Connection labeled FC1
The SNC Connection labeled FC2
Private Target
Private Initiator
Private Target and Initiator
Public Target
Public Initiator
Public Target and Initiator
Meaning
The SNC Connection labeled FC1
The SNC Connection labeled FC2
page 193