ADIC Scalar 100 User Manual page 240

setSnaCCLun [newLUN]
The setSnaCCLun command reassigns the SNC's Command and Control LUN to the
specified value.
newLUN is the new value for the Command and Control LUN. Valid values are 0 through
127.
The new setting takes effect immediately. The previous value is removed from the device
map and database and a trap is generated indicating that the device was removed.
If the new LUN is not currently in use, a new entry is added in the device map and
database. A trap will be generated indicating the new device was added.
If the new LUN is already in use, the Command and Control LUN will be disabled. It will
remain disabled until the device mapped at the requested LUN is removed and deleted
from the database. In this case, you can use the mapRebuildDatabase command to
remove the previous LUN assignment and to allow the new Command and Control LUN
to be enabled.
setTimeHost
The setTimeHost command adds a host running timeserver to the SNC system. The
"setNettime 1" command must already have been issued. To add a host named
Cronos to the system enter the following command:
SN60023 > setTimeHost "Cronos"
Time Host Cronos value = 0 = 0x0
SN60023 >
sfmAccessApply
The sfmAccessApply command causes the settings that have been changed and stored
in memory to take effect immediately and also saves them to the SFM database.
sfmAccessClear [disable code]
The sfmAccessClear command disables all host access to all LUNs except to LUN 0
(the Command and Control interface). The disable code is 0xfacade02.
The following command example shows how to disable all access.
SN60023 >sfmAccessClear 0xfacade02
value = 0 = 0x0
SN60023 >
page 226
Attention: Because AIX and NT use LUN 0 when they issue a Report LUNs
command, you must make sure that a device is configured at LUN 0.
setSnaCCLun [newLUN]