ADIC Scalar 100 User Manual page 241

sfmAccessSet [hostindex],<Starting LUN>,<Ending
LUN>,<Access>
The sfmAccessSet command sets the access for the specified range of LUNs for the
specified host connection index.
When you enter this command, the settings are stored in memory but are not applied until
you enter the sfmAccessApply command. The following example shows how to
enable the host at connection index 1 to access LUNs 2 through 32. Existing hostindex
values can be determined by looking at the "Id" column in the output of the sfmShow -
1 command.
SN60023 > sfmAccessSet 1,2,32,1
value = 0 = 0x0
SN60023 >
sfmActiveSet
The sfmActiveSet command places SFM in the active state. The means that all of the
current access settings are put into effect. You would typically only use this command
after making SFM inactive. See the sfmInactiveSet command.
SN60023 > sfmActiveSet
value = 0 = 0x0
SN60023 >
If SFM is already active, the following is displayed.
SN60023 > sfmActiveSet
SFM: Already Active
value = 21 = 0x15
SN60023 >
sfmConnectionSet [hostindex],
The sfmConnectionSet command sets the host connection information for the host at
the specified connection index. The connection may be a device name, port address, etc.
The following example shows setting the host connection information. Existing hostindex
sfmAccessSet [hostindex],<Starting LUN>,<Ending LUN>,<Access>
Access Value
0 Disables access to the LUNs
1 Enables access to the LUNs
Meaning
host connection string
" "
page 227