ADIC Scalar 100 User Manual page 233

scsiAltIdGet [channel]
The scsiAltIdGet command displays the alternate ID number for a specified channel.
If no channel is specified, alternate IDs are displayed for all SCSI channels.
SN60023 > scsiAltIdGet
SCSIbus AltId ------- ---------------
SCSI 1 1
SCSI 2 6
value = -1 = 0xffffffff
SN60023 >
scsiAltIdSet [channel],[id]
The scsiAltIdSet command sets the Alternate Id for the specified SCSI Channel.
SN60023 > scsiAltIdSet 2,6
Alternate Id set to 6 for SCSI 2
will take effect upon reboot
value = 0 = 0x0
SN60023 >
scsiHostChanGet [channel]
The scsiHostChanGet command displays Host Channel modes for a SCSI channel. If
no channel is specified, Host Channel modes are displayed for all SCSI channels.
SN60023 > scsiHostChanGet
SCSIbus HostChan ------- ---------------
SCSI 1 Channel is Target
SCSI 2 Channel is Initiator
value = -1 = 0xffffffff
SN60023 >
scsiAltIdGet [channel]
Parameter
SCSI Channel Number
ID
Attention: You must reboot the SNC after executing this command for the
new setting to take effect.
Value
1 - 4
0 -15
page 219