ADIC Scalar 100 User Manual page 249

snmpTrapCommunitySet string [view]
" ",
The snmpTrapCommunitySet command sets the community string passed with all
SNMP traps. The View switch must be set to "1" to be accepted by the ADIC Management
Console.
SN60023 > snmpTrapCommunitySet "pathlight",1
Success
value = 8 = 0x8
SN60023 >
snmpWriteCommunityAdd string [view]
" ",
The command adds the specified string to the list
snmpWriteCommunityAdd
of accepted strings for SNMP Write operations (Set).
The View switch must be set
to "1" to be accepted by the ADIC Management Console.
SN60023 > snmpWriteCommunityAdd "pathlight",1
Success
value = 0 = 0x0
SN60023 >
snmpWriteCommunityRemove string
" "
The snmpWriteCommunityRemove command removes the specified string from the
list of accepted strings for SNMP Write operations.
SN60023 > snmpWriteCommunityRemove "pathlight"
Success
value = 0 = 0x0
SN60023 >
sysConfigShow
The sysConfigShow command displays current system parameter settings. The display
shows whether or not the SNC's Command and Control interface is enabled or disabled
and the LUN that is assigned to it, whether or not enhanced tape performance features are
enabled, the MAC address of the Ethernet port; and the SNC's Fibre Channel Node
address.
SN60023 > sysConfigShow
Current System Parameter Settings:
Command and Control Device (CC) : 0 Enabled
LUN : 0
Allow Early Write Status for Tape : 1 Enabled
Allow R/W Acceleration for Tape : 1 Enabled
Enet MAC Address: 0.60.45.16.1.4
FC Node WWN: 10000060.45160104
page 235
snmpTrapCommunitySet "string",[view]