ADIC Scalar 100 User Manual page 234

scsiHostChanSet [channel],[mode]
The scsiHostChanSet command sets the Channel Mode to Target or Initiator for
the specified SCSI Channel.
SCSI Channel Number
Mode
SN60023 > scsiHostChanSet 2,1
Host Chan set to TARGET for SCSI 2 will take effect upon reboot
value = 0 = 0x0
SN60023 >
scsiHostIdGet [channel]
The scsiHostIDGet command displays the Host ID number for a specified SCSI
Channel. If no channel is specified, Host IDs are displayed for all SCSI channels.
SN60023 > scsiHostIdGet
SCSIbus HostId ------- ---------------
SCSI 1 7
SCSI 2 7
value = -1 = 0xffffffff
SN60023 >
scsiHostIdSet [channel],[id]
The scsiHostIdSet command sets the Host ID for a specified SCSI Channel.
SN60023 > scsiHostIdSet 2,7
Host Id set to 7 for SCSI 2
will take effect upon reboot
page 220
Parameter
Attention: You must reboot the SNC after executing this command for the
new settings to take effect.
Parameter
Channel Number
ID
Value Meaning
1 - 4 Selected Channel
0 Initiator
1 Target
Value
1 - 4
0 -15
scsiHostChanSet [channel],[mode]